Find suggested replacement products here
Learn when you might choose one technology over the other in this blog piece: Nd:YAG for Fiber Laser Welding?
Use a picosecond laser for corrosion resistant black marking on stainless steel alloys: UDI marking, banding, part traceability
What's all the fuss about? Read about micromachining with a femtosecond laser in our blog.
What is it and what can you do with it?
Laser soldering and plastic welding; both possible with direct diode lasers
Read our blog piece Bringing Laser Technology In House: 6 Simple Steps to Success which outlines some of the pitfalls and how to avoid when moving from contract manufacturing.
How to design ring projections for hermetic sealing.
Configure your Glovebox here
Flexible circuit design for hot bar reflow soldering
Check out these tips and tricks for successful setup of your micro tig welding application.
Laser or resistance technology? Which do you choose when it's critical to prevent external environmental conditions from penetrating the package?
Projection welding of Fasteners to Hot Stamped Boron Components
Laser Cleaning Metal Improves Battery Pack Reliability. Read the blog now.
Industry increasingly relies on sensors in both factories and products. New sensor technologies mean new product capabilities with improved performance and efficiency.
Fast, clean, efficient! Read the blog.
Dark marks that are resistant to bacterial growth, passivation, corrosion and autoclaving. Read more.
High production rate + high yield = industrial process success. Understanding both the process requirements and production environment allows companies to optimize their production rates resulting in lower cost per part and higher profit.
Visit our blog for more information
Transistor direct current power supplies (also called "Linear DC") produce much the same results as the high frequency inverter by using a high number of power transistors as the direct energy source. This technology provides clean, square wave forms with extremely fast rise time. Used primarily in constant voltage feedback control, transistor DC power supplies are effective in thin foils and fine wire welding applications and for extremely short welds.
Linear DC welders utilize transistor controlled feedback enabling total feedback response times of less than 5 μS. The term Linear DC comes from the waveform that is output from the power supply. No transformer is utilized. The primary limitation to Linear DC technology is the low duty cycles, typically much less than 1 weld per second at less than rated output.
Typically, constant voltage feedback is utilized in conjunction with short weld pulses. Because the feedback response is so rapid, high energy welds with extremely short duration can be used without weld splash or arcing. These short pulses limit the heat stress and the size of the heat affected zone on the weldments. This provides a stronger more ductile weld joint, along with less part deformation, less discoloration, and significantly longer electrode life.
Constant voltage feedback is chosen for two reasons: its ability to prevent arcing and to provide the optimum weld power distribution based on the part resistance. If for some reason the weldments collapse faster than the weld head can follow up, arcing usually occurs. When constant voltage feedback is applied with the feedback response times capable by Linear DC welding this arcing is minimized.
Transistor DC units tend to be larger and heavier than other resistance welding power supply technologies.
Learn more about AMADA WELD TECH and our industry-leading products in our newsroom or at an upcoming tradeshow, webinar or employment event.
An educated customer is a happy customer! Learn more about our eight different manufacturing technologies, watch a video, schedule some training or sign up for our blog in the Learning Center.
Everyone needs a little help now and again. Visit the support center for technical documents, applications assistance, field service, customer service, sales assistance, software downloads and more.